Multi-dimensional characteristics of upward bubbly flows in a vertical large-size square channel

Sun, Haomin; Kunugi, Tomoaki*; Yokomine, Takehiko*; Shen, X.*; Hibiki, Takashi*

International Journal of Heat and Mass Transfer, 211, p.124214_1 - 124214_17, 2023/09

https://doi.org/10.1016/j.ijheatmasstransfer.2023.124214

Recent studies on fuel properties and irradiation behaviors of Am/Np-bearing MOX

Hirooka, Shun; Yokoyama, Keisuke; Kato, Masato

Proceedings of International Conference on Fast Reactors and Related Fuel Cycles; Sustainable Clean Energy for the Future (FR22) (Internet), 8 Pages, 2022/04

Property studies on Am/Np-bearing MOX were carried out and how the properties influences on the irradiation behaviors was discussed. Both Am and Np inclusions increase the oxygen potential of MOX. Inter-diffusion coefficients obtained by using diffusion couple technique indicate that the inter-diffusion coefficient is larger in the order of U-Am, U-Pu and U-Np. Also, the inter-diffusion coefficients were evaluated to be larger at the O/M = 2 than those of O/M 2 by several orders. The increase of oxygen potential with Am/Np leads to higher vapor pressure of UO and the acceleration of the pore migration along temperature gradient during irradiation. The redistributions of actinide elements were also considered with the relationship of the pore migration and diffusion in solid state. Thus, the obtained inter-diffusion coefficients directly influence on the redistribution rate. The obtained properties were modelled and can be installed in a fuel irradiation simulation code.

An Investigation on the control rod homogenization method for next-generation fast reactor cores

Takino, Kazuo; Sugino, Kazuteru; Oki, Shigeo

Annals of Nuclear Energy, 162, p.108454_1 - 108454_7, 2021/11

https://doi.org/10.1016/j.anucene.2021.108454

Analytical study on removal mechanisms of cesium aerosol from a noble gas bubble rising through liquid sodium pool, 2; Effects of particle size distribution and agglomeration in aerosols

Miyahara, Shinya*; Kawaguchi, Munemichi; Seino, Hiroshi; Atsumi, Takuto*; Uno, Masayoshi*

Proceedings of 28th International Conference on Nuclear Engineering (ICONE 28) (Internet), 6 Pages, 2021/08

https://doi.org/10.1115/ICONE28-63286

In a postulated accident of fuel pin failure of sodium cooled fast reactor, a fission product cesium will be released from the failed pin as an aerosol such as cesium iodide and/or cesium oxide together with a fission product noble gas such as xenon and krypton. As the result, the xenon and krypton released with cesium aerosol into the sodium coolant as bubbles have an influence on the removal of cesium aerosol by the sodium pool in a period of bubble rising to the pool surface. In this study, cesium aerosol removal behavior due to inertial deposition, sedimentation and diffusion from a noble gas bubble rising through liquid sodium pool was analyzed by a computer program which deals with the expansion and the deformation of the bubble together with the aerosol absorption considering the effects of particle size distribution and agglomeration in aerosols. In the analysis, initial bubble diameter, sodium pool depth and temperature, aerosol particle diameter and density, initial aerosol concentration in the bubble were changed as parameter, and the results for the sensitivities of these parameters on decontamination factor (DF) of cesium aerosol were compared with the results of the previous study in which the effects of particle size distribution and agglomeration in aerosols were not considered. From the results, it was concluded that the sensitivities of initial bubble diameter, the aerosol particle diameter and density to the DF became significant due to the inertial deposition of agglomerated aerosols. To validate these analysis results, the simulation experiments have been conducted using a simulant particles of cesium aerosol under the condition of room temperature in water pool and air bubble systems. The experimental results were compared with the analysis results calculated under the same condition.

Annual report of Engineering Services Department on JFY2018

Engineering Services Department

JAEA-Review 2019-044, 96 Pages, 2020/03

JAEA-Review-2019-044.pdf:6.11MB

The Engineering Services Department is in charge of operation and maintenance of utility facilities (water distribution systems, electricity supply systems, steam generation systems and drain water systems etc.) in whole of the institute. And also is in charge of operation and maintenance of specific systems (power receiving and transforming facilities, an emergency electric power supply system, an air/liquid waste treatment system, a compressed air supply system) in nuclear reactor facilities, nuclear fuel treatment facilities and usual facilities or buildings. In addition, the department is in charge of maintenance of buildings, design and repair of electrical/mechanical equipments. This annual report describes summary of activities, operation and maintenance data and technical developments of the department carried out in JFY 2018. We hope that this report may help to future work.

Identification of penetration path and deposition distribution of radionuclides in houses by experiments and numerical model

Hirouchi, Jun; Takahara, Shogo; Iijima, Masashi; Watanabe, Masatoshi; Munakata, Masahiro

Radiation Physics and Chemistry, 140, p.127 - 131, 2017/11

BB2016-0282.pdf:0.39MB

https://doi.org/10.1016/j.radphyschem.2017.02.005

Application of turbidity measurement for evaluation of two-phase separation in ,-dialkylamides-nitric acid systems

Tsutsui, Nao; Ban, Yasutoshi; Hakamatsuka, Yasuyuki; Urabe, Shunichi; Matsumura, Tatsuro

Proceedings of 21st International Conference & Exhibition; Nuclear Fuel Cycle for a Low-Carbon Future (GLOBAL 2015) (USB Flash Drive), p.1153 - 1157, 2015/09

,-Dialkylamides are promising alternative extractants to tri--butyl phosphate in the reprocessing of spent nuclear fuels, but the two-phase separation between their organic and aqueous phases has not been evaluated quantitatively. ,-Di(2-ethylhexyl)-2,2-dimethylpropanamide (DEHDMPA) in -dodecane were agitated with uranyl nitrate-containing nitric acid, and their turbidities and their uranium distribution ratios were measured with respect to the time for the quantitative evaluation. Increasing DEHDMPA, uranium, and nitric acid concentrations enhanced turbidities. Although turbidities decreased with respect to the time, uranium distribution ratios slightly changed, indicating the observed turbidities did not affect these uranium distribution ratios significantly. Therefore, DEHDMPA may act as suitable extractant for uranium in nitric acid from two-phase separation viewpoint, and turbidity may be an indicator for extractant performance evaluation.

Neutron spectra and angular distributions of concrete-moderated neutron calibration fields at JAERI

Yoshizawa, Michio; Tanimura, Yoshihiko; Saegusa, Jun; Nemoto, Hisashi*; Yoshida, Makoto

Radiation Protection Dosimetry, 110(1-4), p.81 - 84, 2004/09

https://doi.org/10.1093/rpd/nch198

The facility of Radiation Standards (FRS) of JAERI has equipped with the concrete-moderated neutron calibration fields as simulated workplace neutron fields. The fields use an Am-Be (37GBq) neutron source placed in the narrow space surrounded by concrete wall and bricks to produce scattered neutrons. The neutron spectra of the fields were measured with Bonner multi-sphere spectrometer system (BMS), spherical recoil-proton proportional counters (RPCs), and a liquid scintillation counter (NE-213). The results were compared with each other, and the neutron spectra and the ambient dose equivalent rate, (10), were agreed well within the uncertainty. The angular distributions of neutron fluence were calculated by the MCNP-4B2 Monte Carlo code to obtain the reference personal dose equivalent rate, (10). The calculated results show that the scattered neutrons have a wide variety of incident angles. The reference (10) values considered the angular distribution were found to be 10-18% smaller than those without consideration.

Subchannel analysis of CHF experiments for tight-lattice core

Nakatsuka, Toru; Tamai, Hidesada; Kureta, Masatoshi; Okubo, Tsutomu; Akimoto, Hajime; Iwamura, Takamichi

Proceedings of International Conference on Global Environment and Advanced Nuclear Power Plants (GENES4/ANP 2003) (CD-ROM), 6 Pages, 2003/09

It is important to evaluate thermal margin of the tight lattice core in the Reduced-Moderation Water reactor (RMWR). In the present study, to assess the applicability of subchannel analysis for tight lattice cores, tight lattice CHF experiments were analyzed with COBRA-TF code. For the axial uniform heated rod bundle, the code gives good prediction of critical power for mass velocity of around 500kg/(ms), while the code underestimates it for lower mass velocity and overestimates for higher mass velocity. The predicted BT position was outer channels and differed from the measured position. For the axially double-humped heated bundle, the code gives good prediction for mass velocity of around 200kg/(ms), and overestimates for higher mass velocity. It turned out that the two-phase multiplier of friction loss have a large influences on the flow distribution among the subchannels. To improve the calculation accuracy, it is required to predict precisely the flow distribution including the prediction of pressure distribution in a tight lattice bundle.

Neutronic study on coupled hydrogen moderator for J-PARC spallation neutron source

Kai, Tetsuya; Harada, Masahide; Teshigawara, Makoto; Watanabe, Noboru; Ikeda, Yujiro

Proceedings of ICANS-XVI, Volume 3, p.657 - 666, 2003/07

Neutronic design studies were carried out on the J-PARC coupled H moderator. The highest time- and energy- integrated intensity below 15 meV, pulse peak intensity at 2 meV and 10 meV, were given by 100% para-H moderators, but the optimal moderator thickness was different for each: more than 220 mm, about 120 mm and 80 mm, respectively. Finally, we concluded 140 mm was the optimal thickness for the 100% para-H coupled moderator. Cold neutron distributions on the moderator viewed surface were found to exhibit an intensity-enhanced region at a picture frame part near premoderator. This rather peculiar distribution suggested that the moderator and the viewed surface must be designed so as to take the brighter region near premoderator in use. The intensity decreases along with beam-extraction angle to the normal direction down to about 70% at 25.4. Then, we propose a cylindrical shape coupled moderator which brings about a slight intensity decrease for 0 but a increase in the averaged intensity over the angles of interest.